Gazer F122G, Руководство пользователя

Страница: 37 / 60

RU
37
Соедините корпус
видеорегистратора с
креплением на лобовое
стекло.
Ослабьте контргайку 1 ,
повернув ее против
часовой стрелки.
Отрегулируйте положение
регистратора на креплении
и задайте направление
съемки. Зажмите
контргайку 1 , повернув ее
по часовой стрелке.
Установите видео регистратор
и проложите кабель питания
примерно так, как показано
на рисунке, используя
набор монтажных клипс.
Распределите клипсы на
лобовом стекле равномерно
для закрепления провода
питания.
Для снятия
видеорегистратора с
крепления сначала
надавите на язычок 1 .
Затем, удерживая язычок,
отсоедините регистратор с
крепления, сдвинув его в
сторону 2 .
Recommendation: Install your MVR as high as possible (MVR
frame right next to the rear view mirror or behind it) in the
position in which the lens is directed slightly downward at an
angle of about 15°. If the MVR is set too low (on the dashboard
or a bit higher), the recorded videos will not provide full
information about the road situation as it is impossible to see the
front of your vehicle. Therefore, there is no «reference point».
Recordings will be significantly dimmed if the device is set in
parallel with the road or at an upward angle.
Fix the frame and the mount of
the device on the windshield.
Install the MVR and fix the power
supply cable using mounting clips as
shown in the drawing. Place the clips
evenly on the windshield to fix the
cable.
Loosen the screw 1 by turning it
counterclockwise. Adjust the MVR
position on the frame and set the
recording angle. Tighten screw 1 by
turning it clockwise.
To detach the MVR from the mount,
press tab 1. Then, holding the tab,
remove the recorder from the mount by
sliding it to the side 2.
1
3 4
1
1
2
Vacuum mount installation
2
Recommendation: Install your MVR as high as possible (MVR
frame right next to the rear view mirror or behind it) in the
position in which the lens is directed slightly downward at an
angle of about 15°. If the MVR is set too low (on the dashboard
or a bit higher), the recorded videos will not provide full
information about the road situation as it is impossible to see the
front of your vehicle. Therefore, there is no «reference point».
Recordings will be significantly dimmed if the device is set in
parallel with the road or at an upward angle.
Fix the frame and the mount of
the device on the windshield.
Install the MVR and fix the power
supply cable using mounting clips as
shown in the drawing. Place the clips
evenly on the windshield to fix the
cable.
Loosen the screw 1 by turning it
counterclockwise. Adjust the MVR
position on the frame and set the
recording angle. Tighten screw 1 by
turning it clockwise.
To detach the MVR from the mount,
press tab 1. Then, holding the tab,
remove the recorder from the mount by
sliding it to the side 2.
1
3 4
1
1
2
Vacuum mount installation
2
Установка вакуумного крепления