Gazelle GZ1700, Руководство оператора

Страница: 7 / 26

Preparing and Operating the Gazelle
2
8. Holding the pad secure with
one hand, tighten the pad
retainer by turning it clockwise
(Figure 10).
9. Lift the unit to its standing
position. DO NOT allow the
machine to fall to the floor.
Removing the pad
1. Holding the pad secure with one hand, turn the pad
retainer counter-clockwise and remove (Figure 11).
2. Detach the pad from the pad holder (Figure 12).
Machine Operation
1. Unwrap the electrical cord from the cord hooks.
Check to make sure a pad is installed.
2. Secure the power cord before connecting to a
GROUNDED wall receptacle.
• Form a loop in the power cord and pass up
through the top of the cord holder (Figure 14).
• Bring the loop over the cord holder, and pull to
tighten (Figure 15).
CAUTION! Always secure cord.
Be careful not to trip over
the electrical cord.
• Insert the plug into a
GROUNDED electrical wall
outlet or receptacle
(Figure 16).
This is a commercial electric burnisher, use only on
a dedicated circuit. Do not use on circuits with other
electrical equipment. The minimum amperage of the
site electrical breakers should be as follows:
GZ1700/GZ2000- 20A, GZ1700C/GZ2000C - 15A,
GZ1720E/GZ2020E/GZ2020K - 10A.
Use only the extension cord supplied with the
burnisher. Do not use more than one extension
cord. The total length of the extension cord should
not exceed 50 feet (GZ1700, GZ2000, GZ1700C,
GZ2000C) or 25 meters (GZ1720E, GZ2020E,
GZ1720K).
3. Holding the operating handle, step on
the handle release pedal (Figure 17).
The handle is now unlocked.
CAUTION! Never begin operation when
the handle is locked in its upright
position.
4. Hold the handle at a comfortable height.
Hold the cord together with one grip to keep it out of
the buffing area.
WARNING! Do not allow the power cord to come
into contact with the rotating pad.
Figure 10
Figure 12 Figure 11
Figure 13
Figure 14
Figure 15
Figure 16
Figure 17
This floor machine is provided with a grounded
plug as shown. It is intended for use on a nominal
120 volt circuit. If a properly grounded receptacle is
not available, an adapter should be installed as
shown if the outlet box that houses the receptacle
is grounded. Be sure to fasten the grounding tab
with a metal faceplate screw.
120V Machines: