2
1.3
Function
The tool includes an automatic reset device that returns the piston to its original
position when it reaches its maximum output force.
Manual reset device can manually reset the piston in case of operation error.
The head can be rotated 360 degrees to adapt to operations under tight angles or
difficult conditions.
Alarm sounds and indicator lights when error occurs.
One-button control. With only one button, it's easier to hold than the two-button
one.
Lithium battery, it is recommended to charge the battery every two months. Compared
with nickel metal hydride battery, its storage capacity is 50% higher, charging faster,
charging time is shorter.
The temperature sensor makes the tool automatically stop working when the working
temperature reaches 60
℃
for a long time. An error message is displayed, indicating that
the tool cannot continue to work until the temperature drops to normal.
1.4
LED fault display
1.4.1 Low power protection function
In working mode or aging mode, when the battery power is detected to be too low, it enters the
low power protection state and shuts down the motor to ensure battery safety.
Display alarm content: [LOW SOC PROT]
1.4.2 Overcurrent protection function
In working mode or aging mode, when tool overload is detected, it will enter the overcurrent
protection state and shut down the motor to ensure the safety of the equipment.
Display alarm content: [OVER LOAD PROT]
1.4.3 Over temperature protection function
In working mode or aging mode, when the tool temperature is detected to be too high, the tool
