
INSTALLING THE RAIN FLY
1. The tent must be free standing with all seven walls popped out and
the roof collapsed.
2. Slide the rain fly loosely over the tent roof. The short connecting
poles should be on the underside of the rain fly.
NOTE: Make sure that your rain fly is oriented correctly to your
tent before moving onto the next step. The correct orientation
is such that the small triangular flap with a plastic hook is
positioned along the narrow panel of the permanent sleeping
portion of the tent.
3. Starting at one corner, insert the male end of the short poles
attached to the rain fly into the female end of the roof pole.
Repeat this for all four corners.
[ SEE FIGURE 10 ]
4. Enter the tent and push up to pop up the roof panels.
NOTE: Make sure everyone keeps a safe distance from the
outer perimeter of the tent when popping the roof panel open
and closed.
5. Outside the tent, fasten the plastic hook to the eyebolt of the back
panel.
[ SEE FIGURE 11 ]
6. Locate the small diameter multi-section corded pole and assemble
it through the fabric sleeve over the vertical screen door. At each of
the exterior upper corners of the door, there are small grommets for
the ends of the multi-section pole to be placed into. This bows the
multi-section pole and creates additional clearance above the screen
door.
[ SEE FIGURE 12 ]
7. For full rain protection, unroll the large triangular panels along the
length of each side of the tent. The points of these panels can be
fastened to the ground stake that is also being used for the tie down
rope. When not in use, these triangular panels can be rolled up and
stored along the upper seam of the rain fly.
[ SEE FIGURE 13 ]
REMOVING THE RAIN FLY
1. Unhook the plastic hook from the back panel and remove the
multi-section pole from over the screen door.
2. Enter the tent and pull down the roof hubs.
3. Outside the tent, collapse one side panel hub to relieve tension
on the roof poles.
4. Pull all four rain fly poles out of roof pole sockets.
5. Slide the rain fly off of the tent.
6. Re-open the collapsed side panel hub, then enter the tent and
push up on the roof to re-open those panels.
NOTE: The tent is usable with or without the rain fly installed.
Make sure the rain fly is clean and dry before folding and storing.
RAIN FLY
TENT
10
11
GROMMET
GROMMET
POLE SLEEVE
SCREEN MESH END
RAIN FLY ATTACHED
12
13