ZZZ-183.41215MR.0119-21.GP.EN.doc
WEB VERSION
14
Step 1:
Before starting to assemble, please decide where you would like to position the door panels.
1.
Stand up two Regular Frames (A) and affix the panels together at an angle by sliding two
connecting Pieces (I, J) from top to bottom.
2. Next stand up the Frame Next To Door (B) and using Connecting Piece (E) connect it to
previously set Door Frame A, as shown below. Similarly set up a Door Frame (D) by placing the
door frame either on the left or right, using the Connecting Piece (E).
3. When assembling angled Regular Panels (A), you should put the two panels at 135 degree
angle then use the angled Connecting Pieces (I) and (J) slide from top to bottom to affix the
panels together.
4. Frame screening should be facing the outside of the unit.
5. Door frame step down is on the inside of the unit.
Note:
When sliding the part I, J and E into the frames shake the frames for it too slide. Do not
apply excess force. Make sure the edges are clean from any extra paint if necessary use a fine
file.
