5. Part Setting
The part set function allows the user to set part of the system, while leaving certain circuits
isolated.
Enter the four digit PIN code then press the * key followed by the '0' key. The buzzer will
change tone and the LED's for the isolated circuits will flash. The part guard exit time will now
commence and once expired the system will part set.
If your system has not been programmed for part set then an error tone will sound.
Part Setting with Keyswitch
Your system can be part set via the keyswitch, this is achieved as follows.
Insert the key and turn clockwise to the
markings. The LED for the part set isolated
circuits will flash. Remove the key and the
part set exit time will commence. Once the
exit time is complete the panel will part set.
6. Home Setting
The Home set function allows the user to isolate circuits and set part of the system.
Enter the four digit PIN code the press the * key followed by the '6' key. The buzzer will
change tone and the LED's for the isolated circuits will flash. The part guard exit time will now
commence and once expired the system will Home set. If your system has not been
programmed for Home set an error tone will sound.
Note : Home set cannot be achieved via the keyswitch.
7. Setting with Isolated Circuits
The user can isolate circuits on setting the system providing the circuits have been
programmed to isolate, proceed as follows.
Enter the four digit PIN code, then press the * key followed by the number for the circuit you
wish to isolate. Once a circuit has been isolated the relevant LED for that circuit will flash.
The exit time will now commence and once completed the system will set.
If circuits are not programmed to be isolated then an error tone will be generated and the exit
time will continue.
