切換PAL時請將跳線帽取下及切換完成。
頻道
VISION GV-100TX
LCD Monitor
●
頻道切換鍵:按壓切換鍵可更改頻道號碼
●
OSD訊號:傳輸OSD介面訊號。
頻道切換鍵
Channel Selection/Set button
Channel
ON / OFF
Frame adapter bracket
Factory default setting is NTSC.
Jumper JP1 is shorted with a jumper.
(as depicted on photo on the left).
Factory default setting is NTSC.
Jumper JP1 is shorted with a jumper.
(as depicted on photo above).
Store properly the jumper in case you need to
switch back to NTSC camera system.
To switch to PAL mode, remove the Jumper from JP1
(as depicted on photo above).
Audio out
Video out
Audio In
Video In
OSD
訊號
天線
頻道切換鍵
轉接板
Channel Selection/Set button
頻道
Channel display
MENU
-
+
V1 / V2
POWER
●
頻道:內建頻道數量1~7個。
●
頻道切換鍵:按壓切換鍵可更改頻道號碼。
出廠預設值為NTSC系統，切換方式如下。
出廠預設值為NTSC系統
切換PAL時將跳線帽取下即切換完成。
取下跳線帽時請務必保存下來避免遺失。
●
ON/OFF:開關GV-100RX系統電源。
●Channel: Built-in 7 channel selection
Install GV-100TX on aircraft
using the included adapter
bracket. Installation shown
on 500X Quad Flyer.
●
頻道:內建頻道數量1~7個。
●Channel: Built-in 7 channel selection
●Switch screen between V1/V2
(default V1)
●Channel selection SET button: Press the
Set button once to select desired
channel setting.
●Channel selection SET button:
Press the Set button once to select
desired channel setting.
●OSD - On Screen Display
●ON/OFF: Switch to power on/off GV-100RX
●
V1/V2:切換畫面(預設值V1)。
●
轉換螢幕顯示方向。
●
Screen orientation selection
安裝GV-100TX時可使用內附的
轉接板，將GV-100TX安裝至
機體上如下圖示意圖。
Antenna
M2x3
LCD Monitor
LCD Monitor
跳線帽
切換開關
Jumper installed for NTSC system.
Jumper removed for PAL system.
NTSC
PAL
當頻道發送器或接收器的
指示燈閃爍。
這表示電池電量不足，
請盡快更換電池。
Attention
When the Channel indicator
on Transmitter or Receiver is
flashing.
It indicates low battery,
please change battery asap.
請注意
Attention
請注意
Attention
請注意:
為避免損壞發射器，
通電時須確保天線已接妥。
Important Note:
Never power up the transmitter
without the antenna attached or
it will cause irreversible damage
the transmitter.
硬體介紹
P.1
Hardware Description
P.4
信號格式(NTSC & PAL)
示意圖
Switching between NTSC & PAL system
Installation view
安裝
Installation
