
5
Installation of HUD
Placing Sticky Non-Slip mat and reflective film
1. Place the provided sticky non-slip mat on the vehicles dash as a
base for the HUD. Being easy to remove, its location can also be
changed at any time. Position the HUD in the preferred position before
applying reflector film.
2. The reflecting film should be placed on the windscreen above the
HUD to reflect the HUD display towards the driver’s eye level when in
the driver’s seat.
Procedure of pasting the reflective film
1. Lightly spray some water on the windscreen glass position where
the film will be placed
2. Take off the protective layer
(
marked 1 BACK) from the reflective
film, then place the reflective film onto the winddscreen glass.
3. Once position is ideal, you can use a plastic edged squeegee or
something else flat to remove excess water from the reflective film,
until there are no bubbles or water remaining.
4. After a few minutes, the moisture inside the film should evaporate.
5. Remove the protective layer (marked 2 FRONT) from the reflective
film once it is in the final position.