Installation
4
1. Connect the ACC wire to the ACC power supply of the
car, then connect the GND wire to a suitable ground
point.
2. Position the GPS module in a suitable location on the
dashboard in the vehicle to receive optimal signal.
3. It is recommended that the display is installed on the
centre of the dashboard, close to the windscreen to
enable wires to be hidden and ensure a good view for the
driver. Install the display using 3M tape after first cleaning
the surface.
4. After turning on the device for the first time, or after
having moved the device, press and hold the power
button whilst the device is powered on for 3-5 seconds to
reset/zero the pitch and roll angle to ensure that the
values are accurate.
concentrator
External GPS
Module