3] Hang the TV onto the Wall Plate:
First
hook the TV Rails (b and c) over the top of
the wall plate (a), then let the bottom of the
TV Rails rotate in under the bottom of the
Wall Plate as shown in diagram 3-A. Insert
the Safety Bolts (g) into the threaded holes in
the bottom of the TV Rails and tighten them
with the Allen Key (h) so that they sit behind
the bottom tab on the Wall Plate as shown in
diagram 3-B. Finally loosen the knobs and
you are free to adjust your new fl at panel TV.
Sanus Systems
3785 Lexington Ave. N. Saint Paul Minnesota 55126 800.359.5520 www.sanus.com 052003
Loosen Knobs
Left:
Side view of a 42” plasma mounted to
the wall with a VMPL.
Right:
Front view of a VMPL assembled.
Far Right:
Bottom Rail and Safety Bolt.
2] Mount the TV Rails to the back of your fl at panel TV:
Remove the two stand legs from the back of the television by taking out the
four phillips screws. Once these four screws are removed, the television will slide up and forward away from each leg. Now take out the
four exposed M8 bolts and remove the silver spacer. You will use this M8 bolt and lock washer to attach the Left and Right Rails to the
back of the TV as shown in diagram 2-B.
Make sure these bolts are tight!
Also, make sure the TV Rails (b and c) are mounted at an
equal distance from the top of the TV and as close to centered as possible as shown in diagram 2-A. Knobs should face the outside of the
television. Tighten the knobs on both TV Rails lightly so that the mechanism does not move during installation.