Gateway E-9425R, Руководство пользователя

Страница: 65 / 128

Replacing the system board www.gateway.com
59
5
Push the retaining clips (1) to the open position, then slide the control
panel (2) back from the front of the server to disengage it from the locking
tabs and remove it.
6
Holding the new control panel by the edges, align it with the locking tabs,
then place it on the tabs and slide it toward the front of the chassis.
7
Push the retaining tabs to the closed position to hold the control panel
in place in the chassis.
8
Connect the cables that you previously removed.
9
Follow the instructions in “Closing the server case” on page 32 .
10
Replace the bezel by snapping it into place on the front of the server.
Replacing the system board
To replace the system board:
1
Follow the instructions in “Preventing static electricity discharge” on
page 30 . Make sure that you turn off the server, then unplug the power
cord(s) and all other cables connected to the server.
2
Follow the instructions in “Opening the server case” on page 31 .
3
Remove the system fans and fan cage by following the instructions in
“Replacing system fans” on page 46 .
4
Remove the PCI riser assembly by following the instructions in “Installing
and removing PCI expansion cards” on page 43 .
5
Remove the memory modules by following the instructions in “Installing
memory” on page 39 .
6
Remove the heat sinks and processors by following the instructions in
“Replacing or adding a processor” on page 48 .
7
Disconnect all cables from the system board, noting their locations and
orientation. (You will reconnect the cables after you install the new board.)