Gateway ALR 9250R, Руководство пользователя

Страница: 63 / 226

Chapter 3: Components 49
3.
Wear an anti-static wristband grounded to the system chassis and
place processors on a grounded, static-free surface or conductive foam
pad.
4.
Remove the termination card in the lowest numbered empty processor
slot. (Processor slots are numbered from the edge of the system board
toward the center of the board.) With your thumb on the face of the
retention module bracket, wrap your index finger around the tab
protruding from the right edge of the bracket.
5.
Use your index finger to slightly pull the tab outward and to the left.
You should not try to pull the entire bracket; rather, the back of the tab
has a latch that releases when the tab is pulled slightly.
6.
When you have released the right edge of the bracket, rotate it until it
is perpendicular to the front of the retention module.
9250R.book Page 49 Friday, April 9, 1999 9:44 AM