Gateway 200ARC, Сетевое руководство

Страница: 32 / 160

26
Wired Ethernet Networking
www.gateway.com
To set up a network using a router and optional hub or switch:
1
If you are using a hub or switch, plug one end of the power adapter into
the AC connector on the hub or switch and the other end into a grounded,
110V electrical outlet.
-OR-
If you are not using a hub, go to Step 2 .
2
Plug one end of the power adapter into the AC connector on the router
and the other end into a grounded, 110V electrical outlet.
3
If you are using a hub or switch, plug one end of a straight-through
network cable into the uplink port on the hub or switch (identified by a
label or a switch). Plug the other end of the cable into the uplink port on
the router. If the router has only a single port, use the LAN port and set
the switch on the back of the router to crossover (X).
4
Turn on your computers.
5
If you are using a hub or switch, plug one end of a straight-through
network cable into any numbered port on the hub or switch (except the
uplink port). Plug the other end of the cable into the network connector
on the computer. As each computer is connected to the hub or switch, the
corresponding green indicator should light on the front of the hub or
switch, indicating a good connection.
-OR-
If you are not using a hub or switch, plug one end of a straight-through
network cable into any numbered port on the router (except the WAN
port). The WAN port is used to connect the router to the DSL or cable
modem, and is identified by a label or a switch. Plug the other end of the
cable into the network connector on the computer. As each computer is
connected to the router, the corresponding green indicator should light
on the front of the router, indicating a good connection.
6
Repeat Step 5 for each computer on the network.
7
For an Internet connection, plug a straight-through cable into the WAN
port on the router and the other end into the Ethernet jack on the DSL
or cable modem.