Gates Underwater Products MINI LF, Руководство по установке, использованию и уходу

Страница: 19 / 48

MINI LF Housing Setup Page 19
Lens Gear Drives (LGD
’s)

General Notes. This section
addresses the installation of three
LGD’s – 1 x CCW (Counter Clock
Wise) and 2 x CW (Clock Wise).
These designators are applied
because two LGD’s point in a CW
direction and the other in a CCW
direction,
The LGD’s are marked
CCW and CW.
You will install guide bars and drive
shafts that match the lens of your
choice. Information on which guide
bars, drive shafts and port rings to use
for your lens is available on the
support page at
http://www.gateshousings.com/.
 Secure Guide Bars. Insert the guide bars by threading them into the front
bulkhead. Tighten firmly by hand
– no tools are required but wrench flats are
provided on the guide bars should this be necessary.
 Install Drive Shafts. These
are ¼” black delrin and have a flat spot milled into one
end. This end inserts into the drive coupler at the face of the front bulkhead.
Secure gently with the set screw on the coupler. Do not overtighten.

LGD’s mounting.
Install the L
GD’s in their proper orientation
with pivot gear screws facing forward. Slide it onto the guide bar and drive shaft,
then line up the LGD with the lens gear you wish it to access.
The MINI LF includes three
LGD’s – 2x CCW and 1x CW.
Insert the drive shaft into the
coupler. One end of the shaft
will have a small flat spot.
Align this with the set screw,
and tighten gently. Do not
over tighten.
Note: Different Gates housing shown.
Thread the Guide Bar into the
front shell and tighten by
hand.