GATE ARMS+ FOLDARM90, Руководство по установке, Страница: 7 / 12

6
3.5 Drill
⅛”
hole on underside of arm and attach to the Pivot
Bracket with #6 screw.
3.6 Measure the distance from the center of the operator’s
output shaft to the center of the Pivot Bracket’s hinge joint
as shown below. This measure is the “Arm Height”.
3.7 If necessary, cut the Threaded Rod to the “Arm Height”
length minus 2”.
NOTE: Prior to making any cuts, pre-install a
⅜”
nut on the rod to be used as a tool to clean the burrs
and smooth out the cut.
3.8 Install the
⅜”
rod nuts on both ends of the Threaded Rod
(if not already done).
3.9 Screw a Threaded Rod End onto each side of the Threaded
Rod until the Threaded Rod is about half-way through the
Threaded Rod End.
Step 3.6
Measure the distance between these points
See our complete line of LED Safety Light Systems at www.GateArms.com