2
2.
REMOVE EXISTING ARM
Is another brand of articulating arm installed?
If yes, remove it now.
It should look like this.
3.
MARK & DRILL A HOLE 3” BELOW MOTOR SHAFT
3.1
Make a mark 3” below the center of the motor
shaft. If there is a problem using that spot, you can
make your mark between 2” to 3 ½” below the
center of the motor shaft.
3.2
Drill a ½” hole at
the site of the mark,
being careful not to
damage anything on the
inside of the operator.
Step 3.1
Step 3.2
