3.
Press the ›Menu‹-button or the › + ‹ and › – ‹-buttons to select
the program ›Jam‹. Once ›Jam‹ flashes on the LED-display the
program is selected. The LED-display shows the default values
for the temperature and cooking time.
4.
Use the ›Timer / t °C‹-button to reach the time selection
mode. The minute indicator flashes. Use the › + ‹ and › – ‹-buttons to adjust the time. With the
›Hour / Min‹-button you can switch between hours and minutes. The LED-display shows the
pre-set cooking time 35 min. You can adjust the cooking time from 5 minutes to 2 hours.
5.
Press again the ›Timer / t °C‹-button to adjust the temperature. The temperature indicator
flashes. The LED-display shows the preset temperature 100 °C. Use the › + ‹ and › – ‹-buttons to
select the desired temperature.
6.
Press and hold for a few seconds the ›Start / Keep Warm on / off‹-button to start the appli-
ance. The ›Start / Keep Warm on / off‹-button lights up and the countdown of the cooking time
is shown in the time indicator.
7.
The Keep-Warm-Function turns on automatically, immediately after the program is over. If
necessary, this function can be switched off by pressing and holding the ›Start / Keep Warm
on / off‹-button at any time.
8.
After completion of the program an acoustic signal will sound. Depending on the settings of
the appliance, the Keep-Warm-Function will launch (the LED-display counts up the time) or the
appliance will return to standby mode.
9.
To cancel the selected program, to interrupt the cooking process or the Keep-Warm-Function
press and hold the ›Cancel / Keep Warm‹-button for a few seconds.
program Autoclean
It is recommended to use this program to clean your Multicook. The setting range of the time
is 5 minutes to 2 hours in 5-minute steps.
The countdown of this program will start after reaching operating temperature (boiling water
and steam development).
The 24-hour Auto-Start-Function is available for this program.
1.
Pour about 600-1000 ml of water into the inner pot. Place the steam insert inside the inner pot.
2.
Insert the inner pot into the housing. Make sure that the inner pot is firmly in contact with
the heating element.
3.
Close the lid until it clicks into place. Connect the appliance to the power outlet.
4.
Press the ›Menu‹-button or the › + ‹ and › – ‹-buttons to select
the program ›Autoclean‹. Once ›Autoclean‹ flashes on the
LED-display the program is selected. The LED-display shows
the default values for the temperature and cooking time.
5.
Use the ›Timer / t °C‹-button to reach the time selection
mode. The minute indicator flashes. Use the › + ‹ and › – ‹-buttons to adjust the time. With the
›Hour / Min‹-button you can switch between hours and minutes. The LED-display shows the
pre-set cooking time 30 min. You can adjust the cooking time from 5 minutes to 2 hours.
6.
If necessary, adjust the Auto-Start-Function to start process later.
62