56
damp cloth to avoid burning in any residues, when using the appliance next
time.
8. Thoroughly dry all parts of the appliance after cleaning. Then, leaving the lid of
the appliance in the upper open position, let all parts dry naturally for approx.
30 minutes, with all parts out of reach of young children.
9. After cleaning, reassemble the appliance to avoid loss and damage to the parts
(see below: ‘Assembling the Appliance’).
ASSEMBLING THE APPLIANCE
1. Pull the height control clip to the OPEN position and fold up the lid to the open
position.
2. Check, whether the heating chambers of lid and base as well as the bottom of
the grilling plates are completely clean. Residues within the heating chambers or
on the grilling plates would burn to charcoal during operation. If required, clean
the heating chambers and grilling plates (see above: ‘Cleaning the Appliance’).
IMPORTANT:
The grilling plates cannot be exchanged by each other. The fluted
grilling plate only fits on the lid and the flat grilling plate can only be mounted into
the base. The parts of the appliance can be installed without applying any force!
3. With the drip spout facing to the rear of the appliance, slide the notches of the
fluted grilling plate into the clamps on the lid, then press the front part of the gril-
ling plate n the lid to snap the grilling plate into place.
4. Repeat this procedure on the base to attach the flat grilling plate.
5. Insert the drip tray into the base of the appliance and push the drip tray into
position. The front plate of the drip tray may not protrude the front plate of the
appliance.
The appliance is now ready for use again.
