Gastroback 40128, Инструкция по эксплуатации

Страница: 15 / 32

Trouble Shooting Guide
15
Possible problem Easy solution
Machine will not work when
switched ´ON´
Motor appears to stall when
juicing
Excess pulp building up in
the micro mesh filter basket
Pulp too wet and reduced
extracted juice
Juice leaks between the rim
of the juicer and the cover
of the filter
Bowl surround juice sprays
out from spout
Juicer makes loud noise
when turned on
No juice coming out while
juicing
The safety locking arm may not be correctly engaged in the
vertical operating position with the locking arm located into
the two grooves on either side of the juicer cover (regard
´Assembling the appliance)`.
Wet pulp can build up under the cover if the juicing action
is too vigorous. Try slower juicing action by pushing the food
pusher down more slowly. Clean the integrated pulp container,
the stainless steel filter basket and the juicer cover (regard
´Clear blockage`).
Stop the juicing process. Remove the juicer cover, scrape off
pulp. Re-assemble and begin juicing again. Try alternative
(soft and hard) vegetable and fruit varieties.
Try a slower juicing action by pushing the food pusher down
more slowly. Remove stainless steel filter basket and thoroughly
clean mesh walls with the nylon brush. Rinse the stainless steel
filter basket under hot water. If the fine mesh holes are
blocked, soak the stainless steel filter basket in a solution of hot
water with 10% lemon juice to unblock the holes or wash in
the dishwasher. This will remove excess fibre build up (from
fruit or vegetables) which could be inhibiting the juice flow.
Try a slower juicing action by pushing the food pusher down
more slowly. Fruit and vegetables with a high water content
(tomatoes and watermelon) should be juiced on low speed.
Try a slower juicing action by pushing the food pusher down
more slowly.
Filer basket is not properly snapped into position. Turn the
On/OFF button to OFF. Turn the power OFF. Disassemble the
Design Multi Juicer Digital (refer to ´disassembling`). Re-assemble
(refer to ´assembling`).
Check that the spout is not blocked with pulp. Refer to ´Care
and cleaning`.
40128_designmultijuicerdigital_manual_englisch_0309.qxp 11.03.2009 08:37 Seite 15