GASTOP BR2, Инструкция по эксплуатации

Страница: 13 / 60

13
PL
DEvICE
- BR2 / GA2
MOTOR - OPERATING CHECKLIST (BR2, ZA2)
1. Check whether the controller display shows a „motor error” message which may indicate bad connection between the controller and the
motor.
2. Check whether the motor, when turned, generates sounds indicating mechanical damage to the internal transmission which may have
resulted from excessive tension of the v-belt or over-tightening of the mounting bolts (2a) resulting in the clutch being inoperable.
3. Check motor cables. If motor cables are reversed, the motor may operate non-stop or turn in the opposite direction. Frequent changes
in motor direction may also occur.
ELECTROMAGNETIC LOCKS - OPERATING CHECKLIST (BR2)
1. Check whether electromagnetic locks (1a, 1b) are connected to proper output terminals of the controller (1c) (whether they are not reversed).
2. Manually check (when the device is disconnected from the power outlet) whether the coil’s core is free to move and the coil’s internal
spring automatically moves the core out of the coil.
ELECTROMAGNETIC BRAKE - OPERATING CHECKLIST (BR2, ZA2)
1. Check whether the brake is properly connected to the controller.
2. Use the ohmmeter to check the resistance of the electromagnetic brake which should be above 5 Ohm.
3. Check whether, when the device is disconnected from the power outlet, there is a gap between the upper and lower elements of the
brake (make sure the „free output” option is deactivated in the „SETTINGS” menu of the controller).
24V 0 V
1
3a
3b
2
1a
1b
1c
1
2
3
2a