General
These assembly instructions should be read in con
-
junction with the “General” Operators Manual sup
-
plied. They are intended to provide model specific
details in addition to those in the General operators
Manual.
All Machine set-up should be conducted on flat lev
-
el ground to ensure even set-up across the machine.
Pull
The pull on the Gason Delta wing will generally be
shipped in a vertical position and some assembly
will be required prior to conecting to the tractor.
The below image shows the position the pull it likely
to be shipped in.
The Pull is a heavy components and will require the
use of a crane or forklift to be moved into position.
Rotate pull to a horizontal position and fit hydraulic
cylinder and spring adjuster. Once complete fit PTO
shaft from idler shaft to tee box. Prior to fitting In
-
put PTO read General Operators manual to ensure it
is cut to correct length to suit and is tightened cor
-
rectly.
Rear Crank
The rear crank on your Gason Delta Mower is likely
to be shipped in the position shown above. Remove
all tie downs and rotate crank again using a crane
or forklift to sit wheels on the ground, connect hy
-
draulic cylinders to crank plate and position wheels
to allow bolts to be put into crank plates to secure.
7
7
Assembly Instructions
