FUEL
Mix a regular
grade
gasoline(leaded
or
unleaded,
alcohol-free)
and
a
quality-proven
motor oil for air
cooled 2 cycle
engines.
Recommende
d mixing ratio:
Condition
Gasoline: Oil
Up to 20 hours
u
s
e
2
0
:
1
After
2
0
h
o
u
rs
use
25:1
25:1 Mix Chart
Gasoline liters 1 2 3
4 5
2-cycle oil ml. 40 80 120
160 200
Keep open flames away from
the area where fuel is handled
or stored. Mix and store fuel
only in an approved gasoline
container.
Most engine troubles are used,
directly
or indirectly, by the fuel used
on the
machine. Take special care not
to mix a
motor oil
for
4
cycle
engines.
CHAIN OIL
Use motor oil SAE#10W-30 all
year round or SAE #30-#40 in
summer and SAE #20 in
winter.
Do
not
use
wasted
or
regenerated oil that can cause
damage to the oil pump.
STARTIN
G ENGINE
1.Fill fuel and chain oil tanks
respectively, and tighten the caps
securely.(F7)
2.Pull the chock knob out to close
chock.(F8)
3.Put the switch to on”1” position.(F9)
4.Pull the starter handle several times
until first firing sound is heard. Push
the chock knob all the way in to open
the chock. Pull the starter handle again
until engine run.(F9)
5. Push the throttle lever and throttle
inter lock once and loosen it make the
engine run at idle speed.(F11)
6. To stop the engine, push the engine
switch to stop(0) position.
(1) Chain oil
(2)Fuel
(3)Switch
(4)Throttle lever
(5)Throttle interlock
(6)Choke knob
When
restarting
immediately
after
stopping the engine, leave the choke
knob at the open position.
6. While holding the saw unit
securely on the ground, pull
the starter rope vigorously.
(F12)
Do not start the engine while hanging
the chain saw with a hand. The saw
chain may touch your body. It’s very
dangerous.
7.When engine has ignited first, push
in the choke knob and pull the starter
again to start the engine.
8.Allow the engine to warm up with the
throttle lever pulled slightly
。
。
。
。
WARNING
Keep clear of the saw chain as it will
start rotating upon starting of engine.
NOTE
NOTE
NOTE
WARNING
