background image

5

4

Do not use the heater in areas where there is a risk of 
explosion or fire from flammable gases. Ensure that 
the heating area is kept clear of combustible materials. 
Do not use the heater in damp areas, without suitable 
ventilation. This heater is not designed for use within 
1m or above a water source. Do not place within one 
metre (1m) of any water source. Do not place directly in 
front of, below or above any power points or switches.
Fire risk exists if this heater is covered by or positioned 
near combustible materials.
•  This heater is intended for domestic/ household use 

only.

•  This heater is designed for outdoor use.
•  Always ensure that this heater is installed as per the 

requirements noted in New Zealand Standard AS/
NZS 3000:2007.

•  Always keep heater at least one metre (1m) from 

combustible materials.

•  DO NOT locate this heater directly below, above or 

in front of the power supply socket or switch.

•  DO NOT use this heater in either a bathroom or 

ensuite.

•  DO NOT use a 3rd party timer, or programmable 

system with this heater.

•  DO NOT clean the heater while the heater is on or 

plugged into the mains power supply.

•  DO NOT touch any part of the heater while on, hot 

surfaces may burn.

•  DO NOT use the heater as a dryer.
•  DO NOT attempt to modify the heater, power cord, 

power plug or the supplied accessories in any way.

•  DO NOT expose the heater to rain, water, or use in 

damp wet conditions.

•  NEVER cover this heater.
•  NEVER carry the heater by its power supply cord.
•  NEVER use with the power cord coiled, bundled up 

or tied up. Always extend fully before use.

•  Always ensure that the power cord is fully extended 

and NOT in contact with any part of the heater.

•  NEVER use the heater if any part of it is damaged.
•  Ensure that the heater is disconnected from the 

mains supply when installing, cleaning or removing/
installing.

•  Ensure this heater is not left on when unattended.
•  Ensure the heater is not used in areas where 

flammable gases are present, e.g. paint, petrol etc.

•  Always allow the heater to cool, about one (1) hour 

after the heater has been turned off, before cleaning 
the heater.

•  Always ensure that the heater is kept clean and free 

from dust.

•  Only use this heater on a level surface.
•  Always turn the heater OFF at the power point when 

not in use for extended periods of time.

WARNINGS

SPECIFIC SAFETY INSTRUCTIONS

Содержание Radion GM135-040









Отзывы: