7. The hose assembly should be properly located out of
pathways where people may trip over it. The hose
must be protected from contact with hot or sharp
surfaces both during use and while in storage. The
hose assembly should be visually inspected prior to
each use of the heater. If excessive abrasion or wear is
evident, or the hose is cut, it must be replaced prior to
operating the heater. The replacement hose assembly
may be obtained from the manufacturer.
8.
DO NOT use any pressure regulator or hose
assembly other than those supplied with the appliance.
Replacement pressure regulator and hose assembly
must be those specified.
Replacement parts may
be obtained from the manufacturer or your local sales
representative.
9. Installation and use of this heater must conform with
local codes or, in the absence of local codes, with the
Standards of Storage and Handling of Liquefied
Petroleum Gases.
10. This heater is designed to operate with a standard 9Kg
propane cylinder with Approved Cylinder Connection.
11. The valve outlet must be maintained in good condition.
When the cylinder is not in use, be sure to cover it with
a dust cap. A leak test should be performed with soapy
water whenever connecting a new cylinder. NEVER use
a match to test for leaks.
12. The propane cylinder must be turned off whenever the
heater is not in use. When the heater is to be stored
indoors, the propane cylinder and the heater must be
disconnected and the cylinder stored in accordance
with the Standard for Storage and Handling of Liquefied
Gases. (ie: Not indoors, but in a dry and well ventilated
area.)
13. The patio heater has been designed with several safety
features which include a tip over switch.
Screw the coupling nut of regulator into the cylinder valve outlet.
(Cylinder not included)
POL CYLINDER CONNECTION DEVICE
Type of Gas
Propane
(NZ-LPG)
Consumption
45 MJ/h
Operating Pressure
2.75 kPa
Injector Size
2.0 mm
Any modification to the heater not described in the
installation instructions may compromise the safety of this
appliance. Special concern is as follows:
(1)
DO NOT shorten post length;
(2)
DO NOT bypass thermocouple safety;
(3)
DO NOT operate heater without a reflector;
Clothing or other flammable materials should not be hung
from the heater, or placed on or near the heater. The area
above the post may be extremely hot. Direct contact with
these metal surfaces should be avoided in order to prevent
burns or clothing ignition.
Heater specifications can be found on the data label inside the cylinder cover.
Storage of an appliance indoors with the
cylinder attached is only permitted if the size
of the cylinder complies with AS/NZS 1596;
otherwise cylinders must be stored outdoors in
a well ventilated area.
