3
e. Any cleaning agent used on the appliance
should be of a non-combustible and non-
corrosive nature.
7. The hose assembly should be properly located
out of pathways where people may trip over
it. The hose must be protected from contact
with hot or sharp surfaces both during use
and while in storage. The hose assembly
should be visually inspected prior to each use
of the heater. If excessive abrasion or wear is
evident, or the hose is cut, it must be replaced
prior to operating the heater. The replacement
hose assembly may be obtained from the
manufacturer.
8. DO NOT use any pressure regulator or
hose assembly other than those supplied
with the appliance. Replacement pressure
regulator and hose assembly must be those
specified. Replacement parts may be obtained
from the manufacturer or your local sales
representative.
9. Installation and use of this appliance must
conform with local codes or, in the absence of
local codes, with the Standards of Storage and
Handling of Liquefied Petroleum Gases.
10.This appliance is designed to operate with a
standard 9Kg propane cylinder with Approved
Cylinder Connection.
11. The valve outlet must be maintained in good
condition. When the cylinder is not in use,
be sure to cover it with a dust cap. A leak
test should be performed with soapy water
whenever connecting a new cylinder.
NEVER
use a match to test for leaks.
12. The propane cylinder must be turned off
whenever the heater is not in use. When the
heater is to be stored indoors, the propane
cylinder and the heater must be disconnected
and the cylinder stored in accordance with the
Standard for Storage and Handling of Liquefied
Gases. (i.e.: Not indoors, but in a dry and well
ventilated area.)
13. The heater has been designed with several
safety features which include a tip over switch.
Screw the coupling nut of regulator into the
cylinder valve outlet.
(Cylinder not included)
POL cYLINDER cONNEcTION DEVIcE
Type of Gas
Propane
Consumption
36 MJ/h
Operating Pressure
2.75 kPa
Injector Size
1.7 mm
Any modification to the heater not described in
the installation instructions may compromise the
safety of this appliance. Special concern is as
follows:
DO NOT bypass thermocouple safety;
Clothing or other flammable materials should not
be hung from the heater, or placed on or near the
heater. The area above may be extremely hot.
Direct contact with these metal surfaces should
be avoided in order to prevent burns or clothing
ignition.
Heater specifications can be found on the data
label.
