5
4
ASSEMBLY INSTRUCTIONS
For best results and your safety, please follow the
instructions carefully. DO NOT modify this product in any
way as the distributor will accept no liability for improper
use.
Remove all package material (including anti-vibration
object on the lamp) and check the heater, supply cord
and plug for signs of damage.
Pay attention to the mounting place and all mounting
material (dowels, screws). See figure 1. Ensure they are
suitable and stable enough for mounting and holding the
heater securely.
Before mounting, the minimum safe mounting distances
and tilt angles shown in the figures below must be strictly
followed.
•
The distance between the bottom edge of the
heater and the floor must be at least 1.8m. See
figure 2.
•
There must be a distance of at least 0.25m between
the heater and the ceiling, roof or other overhangs.
See figure 2.
RESET OPERATION
• Press the Reset button, the power will be adjusted
accordingly (Low, Middle, High, ON/OFF)
• Press the Reset button for at least 4 seconds, the
heater will restore to factory settings
•
There must be a distance of at least 0.5m on each
side of the heater and walls or the like. See figure 2.
•
Recommended degree of tilt of the heater to the
mounting surface is 45°. See figure 3.
Pay attention that the heater is not installed in
excessively windy locations.
Fix the mounting bracket to the wall first.
1.
Take the wall bracket and select the position on
the wall
2.
Mark the holes for the wall bracket and drill
3.
Using 4 suitable screws (not supplied) attach the
wall bracket to the wall. Now assemble the wall
bracket to the heater.
Ensure that the place it is to be installed is secure and
firm. Or connect the appliance to a stand (optional).
Adjust the desired angle of heater and tighten all screws.
Check the screws are secure. Mechanical bearing
pressure and oscillation due to wind or rain could lead to
loosening.
Plug in to the power point and use the remote control to
turn on and test as shown on next page. Then observe
for the first 10-15 minutes that the heater works trouble-
free.
If you do not use for an extended period, please remove
batteries from the remote.
Figure1: Mounting bracket and anchor dowels
provided. Connection from the wall to the infrared
heater.
Figure2: Min. distance to floor, ceiling and wall.
Figure3: Tilt angle.
Figure 4: Max.remote distance
45
°
Figure 3:
Tilt angle.
Figure 1:
Mounting bracket and anchor dowels provided.
Connection from the wall to the infrared heater.
Figure1: Mounting bracket and anchor dowels
provided. Connection from the wall to the infrared
heater.
Figure2: Min. distance to floor, ceiling and wall.
Figure3: Tilt angle.
Figure 4: Max.remote distance
Reset
On
Off
Figure 2:
Minimum distance to floor, ceiling and wall.
Figure1: Mounting bracket and anchor dowels
provided. Connection from the wall to the infrared
heater.
Figure2: Min. distance to floor, ceiling and wall.
Figure3: Tilt angle.
Figure 4: Max.remote distance
0.5m
0.25m
1.8m
2.2M
COVERAGE AREA
4.3M
3.1M
