Gasmate GR1000, Руководство пользователя

Страница: 11 / 16

10 11 10
INSTALLING - WALL MOUNT RANGEHOOD
DUCTING
1. Remove all tape from the ducts butterfly flaps and
ensure they move up and down freely.
2. Position the butterfly flaps up.
3. Position the ducting over the top of the collection
box and butterfly flaps. Note: If unsure about the
ducting please contact a rangehood installer.
4. If using a rangehood installer or roof plumber duct
through ceiling and roof in accordance with the
local, state and national regulations and laws.
POWER
Using a plumb bob or spirit level determine the vertical
line the flue surrounds will take.
The position of the 240V AC wall socket is that it must
be accessible to turn on/off without removing any
covers.
Note: All electrical work must be carried out by a
licensed electrician.
1. Uncoil power cord.
2. Plug into wall socket and turn on.
3. Test the fans and lights as per “Using Rangehood”.
4. If all okay turn off wall socket and unplug power
lead.
FLUE SURROUND
Provided are 2 x flue surrounds both 400mm high.
These are used to finish and cover the motor box and
installed ducting.
1. Lift and fit bottom flue surround, this fits into the
groove in the Rangehood flat top.
2. Mark 1 hole on each side for the flue surround.
Remove flue surround and drill holes.
3. Replace flue surround and secure each side at the
top with suitable screws.
4. Mounting the second flue surround, this goes on the
inside of the one previously installed.
5. Using a spirit level, plumb bob and tape measure
position the flue bracket as high as possible. Once
in correct position mark holes and drill.
6. Secure the flue bracket with suitable screws.
7. Slide the second flue cover inside the first. Make
sure the power cord is clear of the flue surround.
Now fasten to the flue bracket, make sure not to
damage power cord.
8. Push 240V AC plug into power socket and turn on.
Note: Do not damage the power cord during the flue
surround installation.