Gasmate GM135-009, Инструкции по установке, эксплуатации и обслуживанию

Страница: 4 / 8

5 4
Do not use the heater in areas where there is a
risk of explosion or fire from flammable gases.
Ensure that the heating area is kept clear of
combustible materials. Do not use the heater in
damp areas, without suitable ventilation. This
heater is not designed for use within 1m or
above a water source. Do not place within one
metre (1m) of any water source. Do not place
directly in front of, below or above any power
points or switches.
Fire risk exists if this heater is covered by or
positioned close to curtains or other combustible
materials.
• This heater is intended for domestic/
household use only.
• This heater is designed for outdoor use.
• Always ensure that this heater is installed as
per the requirements noted in New Zealand
Standard AS/NZS 3000:2007.
• Always keep heater at least one metre (1m)
from combustible materials.
• DO NOT locate this heater directly below,
above or in front of the power supply socket
or switch.
• DO NOT use this heater in either a bathroom
or ensuite.
• DO NOT use a 3rd party timer, or
programmable system with this heater.
• DO NOT clean the heater while the heater is
on or plugged into the mains power supply.
• DO NOT touch any part of the heater while on,
hot surfaces may burn.
• DO NOT use the heater as a dryer.
• DO NOT attempt to modify the heater, power
cord, power plug or the supplied accessories
in any way.
• DO NOT expose the heater to rain, water, or
use in damp wet conditions.
• NEVER cover this heater.
• NEVER carry the heater by its power supply
cord.
• NEVER use with the power cord coiled,
bundled up or tied up. Always extend fully
before use.
• NEVER use the heater if any part of it is
damaged.
• Ensure that the heater is disconnected from
the mains supply when installing, cleaning or
removing/installing.
• Ensure this heater is not left on when
unattended.
• Ensure the heater is not used in areas where
flammable gases are present, e.g. paint,
petrol etc.
• Always turn the heater OFF at the unit switch
and the power point switch when not in use
for extended periods of time.
• Always allow the heater to cool, about one
(1) hour after the heater has been turned off,
before cleaning the heater.
• Always ensure that the power cord is fully
extended and NOT in contact with any part of
the heater.
• Always ensure that the heater is kept clean
and free from dust.
• Only use this heater on a level surface.
WARNINGS
SPECIFIC SAFETY INSTRUCTIONS