5
4
Using the Battery Monitor
The device is equipped with a multi-level battery monitor
that protects your vehicle battery against excessive
discharging when the device is connected to the on-
board 12V supply.
If the fridge is operated when vehicle’s ignition is
switched off, the fridge switches off automatically as
soon as the supply voltage falls below a set level. The
cooler will switch back on once the battery has been
recharged to the restart voltage level.
In “H” mode, the battery monitor responds faster than in
modes “L” and “M” (see the following table).
Battery Monitor Mode
L
M
H
Switch-off voltage at 12 V 10.1 V
10.5 V
11.1 V
Restart voltage at 12 V
10.9 V
11.4 V
12.4 V
Switch-off voltage at 24 V 21.5 V
22.3 V
24.3 V
Restart voltage at 24 V
22.7 V
23.7 V
25.7 V
This is how to select the battery monitor mode:
1.
Switch on the cooler.
2.
Press the “SETTINGS” button 4 times
3.
Use the “UP” or “DOWN” buttons to select the
battery monitor mode.
The selected mode appears in the display for a few
seconds and will be applied automatically. The display
flashes several times before it returns to the current
temperature.
NOTE:
When the fridge is powered by the battery of a
vehicle, select the battery monitor mode “H”. If the cooler
is connected to a supply battery, the battery monitor
mode “L” will suffice.
When the fridge is switched off by the battery monitor,
the battery will no longer be fully charged. Avoid starting
vehicle repeatedly or operating other products with your
vehicle battery without recharging your vehicle battery.
When operating via battery power supply, display
switches off automatically if battery voltage is low. The
display then displays “E1”.
Using the Emergency Override Switch
The emergency override switch is located on the control
panel. For normal operation the switch is in “normal”
position.
If an electronic control failure occurs and the display
does not work, switch the fridge/freezer to “emergency
override” position.
The fridge/freezer will work at full cooling capacity which
may freeze contents.
MAINTENANCE & STORAGE
Never clean the fridge/freezer under running water.
The fridge/freezer must be defrosted regularly for efficient
operation.
If the appliance is to remain unused for a long period,
disconnect, clean and leave the lid slightly open during
storage to prevent unpleasant odours.
DO NOT use scouring pads, powdered cleaners, bleach
or cleaners containing bleach because these products
can scratch or damage the surface finishes.
When storing the fridge, remove both cords, loosely coil
and store inside.
Make sure that the air inlet and outlet vents on the fridge/
freezer are free of any dust and dirt, so that heat can be
released.
Defrosting the fridge/freezer
Humidity can form frost in the interior of the cooling
device or on the vaporizer. This reduces the cooling
capacity. Defrost the device from time to time to avoid
frosting.
Never use hard or pointed tools to remove ice or to
loosen objects which have frozen in place.
To defrost the cooler, follow these steps below:
1.
Take out all contents out of the fridge/freezer.
2.
Turn off the fridge/freezer.
3.
Remove the bungs in each compartment.
4.
Leave the lid slightly open until defrosted.
5.
Dry the inside of the fridge/freezer before returning
contents.
Energy saving tips
Choose a well-ventilated location which is protected
against direct sunlight.
Allow warm food or beverages to cool down first before
placing them in the fridge to keep them cool.
Do not open the fridge more often than necessary.
Defrost the fridge once a layer if ice forms.
Avoid unnecessarily low temperatures.
Содержание GM009-030
Страница 7: ...7...
