7
6
GENERAL ASSEMBLY
CONNECTING & DISCONNECTING TO THE
GAS SOURCE
Familiarise yourself with the general information and
safety guidelines located at the front of this manual.
DO NOT USE AN ADAPTOR AT THE CYLINDER
CONNECTION
Check
1. The cylinder is filled. A sloshing sound will be heard
when shaken.
2. The burner controls are in the ‘OFF’ position.
Connecting
1. Ensure cylinder valve is in its full off position.
2. Check for any damage to either the cylinder
connection or the hose. NEVER attempt to use
damaged equipment.
3. When connecting the hose to the cylinder tighten the
nut to a positive stop by hand or spanner.
4. Open cylinder valve fully. If a leak can be heard at
either end of the hose turn cylinder off and tighten
joint. Wait 5 minutes before re-testing and use a
soapy water solution to check the joint. If bubbles
appear, the connection will need to be re-tightened.
Disconnecting
1. Ensure the burner control is in the ‘OFF’ position.
2. Ensure cylinder valve is in the full off position.
For storage and cylinder exchange, disconnect hose
at the cylinder only, DO NOT disconnect hose from
appliance.
NEW LCC27 GAS CYLINDER AND
APPLIANCE CONNECTION
This appliance has been supplied with the new safer gas
cylinder connection Safe Lok LCC27 Type 27 regulator
and hose connection.
This connection will only connect to a 4kg or 9kg gas
cylinder with an LCC27 Type 27 cylinder valve. This
connection will NOT connect (screw) to the old type 21
POL gas cylinder valve.
ELECTRICAL DATA
IMPORTANT
This product is fitted with a sealed electrical connection
plug that is compatible with the product, the mains
supply for Australia and meets the requirements of
international standards. This product must be connected
to a supply voltage that is equal to that stated on the
rating label. If the mains connection plug or power cord
becomes damaged it must be replaced with a complete
assembly that is identical to the original, and this must be
replaced by an authorised service centre. Always follow
the Australian requirements for connection to the mains
supply. If in doubt always consult a qualified electrician.
Technical Specification
Model No
YOSAA12002000A
Voltage Input
220-240V AC 50Hz
Voltage Output
12V - 2000mA
LIGHT GLOBES
For replacement light globes please contact
Sitro Group Australia.
