2
3
specific safety Instructions
WarNINGs
Do not use the heater in areas where
there is a risk of explosion or fire from
flammable gases. Ensure that the heating area
is kept clear of combustible materials. Do not
use the heater in damp areas, without suitable
ventilation. This heater is not designed for use
within 1m or above a water source. Do not place
within one metre (1m) of any water source. Do
not place directly below or above any power
points or switches.
Fire risk exists if this heater is covered by
or positioned close to curtains or other
combustible materials.
• This heater is intended for domestic/
household use only.
• Always ensure that this heater is installed
as per the requirements noted in Australian
Standard AS/NZS 3000:2007.
• Always keep heater at least one metre
(1m) from combustible materials.
• DO NOT locate this heater directly
below or above the power supply socket or
switch.
• DO NOT use this heater within 1 meter
or above any water source.
• DO NOT use this heater in either the
bathroom or ensuite without suitable
ventilation.
• DO NOT use a 3rd party timer, or
programmable system with this heater.
• DO NOT clean the heater while it is on or
plugged into the mains power supply.
• DO NOT touch any part of the heater
while on, hot surfaces may burn.
• DO NOT use the heater as a dryer.
• DO NOT attempt to modify the heater,
power cord, power plug or the supplied
accessories in any way.
• DO NOT expose the heater to rain,
water, or use in damp wet conditions.
• NEVER cover this heater.
• NEVER carry the heater by its power supply
cord.
• NEVER use with the power cord coiled,
bundled up or tied up. Always extend fully
before use.
• NEVER use the heater if any part of it is
damaged.
• Ensure that the heater is disconnected
from the mains supply when installing,
cleaning or removing.
• Ensure this heater is not left on when
unattended.
• Ensure the heater is not used in areas
where flammable gases are present, e.g.
paint, petrol etc.
• Always turn the heater OFF at the power
point switch when not in use for extended
periods of time.
• Always allow the heater to cool, about
one (1) hour after the heater has been
turned off, before cleaning.
• Always ensure that the power cord is fully
extended and NOT in contact with any part
of the heater.
• Always ensure that the heater is kept
clean and free from dust.
• Only use this heater when securely
attached to the mounting surface.
• Do not look directly at the heater when
it is on.
cleaning
Always ensure that if the heater has been recently used, leave for one (1) hour to cool before cleaning.
1. Turn off and disconnect from mains
power, allow to cool.
2. Wipe unit over with a damp clean soft
lint free cloth.
3. For stubborn marks you can use a mild dish washing solution on a damp clean soft lint free cloth.
NEVER allow water or a mild dish washing solution
to enter or drip onto the heater.
NEVER use solvents, e.g. Petrol, Toluene,
Methylated Spirits etc to clean the heater, as these will
damage the surface finish and may cause a fire when unit is next used.
