Gasmate AVENIR GM174-054, Руководство пользователя, Страница: 17 / 24

17 16
LIGHTING PROCEDURE
Burner Operation & Ignition System Check
1. Open the hood of the barbecue before attempting to
light the burners.
2. Turn all the control knobs clockwise to “OFF” position.
3. With cylinder valve in ‘OFF’ position press the igniter
button. Check for sparking to the burners.
4. If spark is not evident at the burner ignition point,
check that the ignition lead is firmly attached to the
control and sparker tip.
5. With sparking established turn the cylinder valve ‘ON’.
6. Push and turn control knob anti-clockwise to ‘HIGH’
and press the igniter button again.
7. If the burner fails to ignite after several attempts turn
off gas supply at cylinder valve and the control knob
off (clockwise). Wait five minutes before attempting
to relight with ignition sequence.
8. Following successful ignition, to ignite remaining
burners, turn control knobs to the HIGH position
starting with the burner closest to the ignition burner.
9. Adjust the heat by turning each control knob to the
“HIGH”/”LOW” position.
10. To turn the barbecue ‘OFF’ turn the cylinder valve to
the ‘OFF’ position, then turn the control knobs on the
barbecue clockwise to the ‘OFF’ position.
If re–ignition is necessary while the gas barbecue is still
hot, you must wait for a minimum of 5 minutes before
commencing to re–ignite (this allows accumulated gas
fumes to clear).
Side Burner & Rear Burner
1. Lift up the cover and ensure it is always open when
the side burner is alight. Open the barbecue hood to
light the rear burner.
2. Push and turn the control knob anti-clockwise to HIGH
whilst pressing the ignitor (a single click is heard). This
will light the side burner or read burner. Observe if the
burner has lit. If not, repeat this process.
3. If the burner fails to light after several attempts turn
the control knob to OFF and wait a few minutes before
attempting re-ignition.
Problem Possible Reason Solution
Burner will
not ignite
Valve on cylinder is closed Open valve on cylinder
Control knob is closed Turn knob to high when lighting
Electronic igniter is faulty Use a long barbecue match
Food is not
cooking or
is taking too
long
Burner has gone out Check that the gas bottle is not empty and
re-ignite the burner
Cooking surface was not given enough time to
warm up before the food was applied Remove the food and give the burner time to
warm the cooking surface (5-10 minutes)
There is too much food on the cooking surface Cook smaller portions
OPERATION
Note: If the appliance cannot be adjusted to perform correctly it should not be used until serviced or repaired.
Burner Operation & Ignition System Check
IMPORTANT:
• IMPORTANT: Before connecting and
disconnecting barbecue to gas source, make sure
burner controls are in ‘OFF’ position.
• CAUTION: When the barbecue is not in use, the
gas must be turned off at the cylinder.
• Check that the seals between the appliance
and the gas cylinder are in place and in good
condition before connecting the gas cylinder.
• Do not use this appliance if it has damaged or
worn seals.
• Check performance of burner prior to installing
BBQ plates.
• NOTE: If for some reason, ignitor fails to produce
a spark at the electrode, BBQ can be lit by a long
BBQ match. With hood open insert ignited match
into burner lighting hole positioned on the right
hand side of the BBQ body (underneath side
shelf). Push and turn the far right control knob to
HIGH. Burner ignition can be checked through
this hole. Subsequent burners will cross light.
• Do not smoke when attempting to ignite BBQ.
• Never use volcanic rock, heat beads or other
material.
• Always use protective gloves when handling hot
components.