![background image](http://html1.mh-extra.com/html/gasboy/islander-prime/islander-prime_instruction-and-installation-manual_3666678066.webp)
Installation
5.5 Installing Communication Interfaces
Page 54
MDE-5411A ForeHB Islander Prime Installation Manual · October 2018
5.5 Installing Communication Interfaces
The Islander Prime pedestal pole has three slots in which communication interface cards can
be added. Each communication interface card is embedded into a blade, which slides into the
slot. Slot 1 and Slot 2 can support either mechanical or electronic interfaces, and Slot 3
supports only electronic interfaces.
Detailed below are instructions on how to insert communication interface blades into the slots,
followed by wiring procedures for each specific type of interface. The wiring is performed in
the Islander Prime terminal block only. The wires should be pulled from the conduits that
protrude from the installation base, or in the opposite direction, from the terminal block to the
device in the homebase station.
The maximum load for each bus is 8 devices/pumps.
5.5.1 Adding Communication Interface Blades to the Pedestal
To add a communication interface blade to the Islander Prime pedestal, proceed as follows:
1
Caution
: Risk of electric shock. Disconnect all power before servicing; there may be
more than one disconnect switch.
Attention
: Risque de choc électrique. Débrancher toute l'alimentation avant
l'entretien, il peut y avoir plus d'un sectionneur.
CAUTION
Turn off all power to the pedestal and the pumps, and fully disconnect all power sources.
For optimum configuration, each line should be connected to up to 6 devices.
TIP
Содержание Islander Prime
Страница 4: ...This page is intentionally left blank...