GAS MAD PB1, Руководство пользователя

Страница: 9 / 16

8
HOW TO
INSTALL PRE-LOADED ENCLOSURE
Since the enclosure is pre-loaded with MAD midrange speakers and tweeters, the installa-
tion is very simple. Just connect it with your amplifier and get ready to play LOUD! To take
your SPL setup to the next level, we’ve included a whole new feature, we’re calling it AST.
Active Smart Terminal.
Before installing your brand new pre-loaded enclosure, make sure that you have everything
you need. Have the right tools ready, and make sure that you have the necessary know-
ledge/skill to perform the installation properly. Preparation and knowledge is crucial!
with AST connector
(passive mode)
The AST feature is based on the idea to give you full power over
your SPL enclosure. The AST connector gives you the choice to
connect the woofers and tweeters, for a passive mode connection
to one amplifier. Or you can remove the connector, and connect
separate amplifiers to the midrange speakers and to the tweeters
for an active mode/setup (see the following page for setup
suggestions). This improves the sound quality and increases the
Sound pressure Level. To make your LOUD system even LOUDER!
without AST connector
(active mode)
When the AST connector is not in place, the tweeter’s built-in capacitor is still
active to protect them from noise issues such as DSP/amplifier failures that
could damage the tweeters.
2 Ohm 4 Ohm 2 Ohm