GAS GAS EC FSE 450, Руководство по обслуживанию

Страница: 48 / 71

-
46
-
WARNING
Using a filter with an incorrect design may cause engine malfunction.
Use the oil filter with the genuine GAS GAS design or equivalent for
your motorcycle.
WARNING
An error in the fitting of a new element may cause engine malfunction.
The engine oil will not flow if a new element is not correctly fitted.
6. Before replacing the oil filter, make sure that the spring (E) and
the o-ring (F) are in the correct position.
NOTE
Fit a new O-ring when the filter is being replaced.
7. Replace the filter cover and put the screws that secure the cover,
but without tightening them too hard (do not exceed the recommended
torque).
8. Replace the drain caps and screw them back on accordingly.
Pour new oil through the dipstick hole. Approximately 1200 ml or
else the required amount.
WARNING
The engine may be damaged if the oil is not used properly or the
specifications recommended by GAS GAS MOTOS are not followed.
Use the type of oil specified in the section on Petrol and Oil
recommendations.
9. Start the engine and allow it to run some minutes. Check for oil
leaking from the filter cover.
10. Check that the oil level is correct according to the oil level
verification process.
(F)
(E)