Remove these three bolts
Leave this bolt in place
Slide blocks even
With each other to
position shown –
Do NOT tighten hand knobs
This hole fits over the bolt head in LS block
Setting Up the Machine:
The squaring arm (gauge) is shipped loose and must be bolted in place before use. Procedure
is as follows:
a) Loosen hand knobs and move sliding mount blocks to the center of machine.
b) Remove both bolts from RS sliding block and the back bolt from L.S. sliding block using the
Allen wrench provided in accessory package.
c) Position gauge as shown in illustration and slide through opening in main housing.
d) Position gauge over remaining bolt on L.S. block.
e) Install bolts removed in step D finger tight.
f) Slide entire assembly up against stop collars at rear of machine and tighten all bolts being
careful not to move blocks away from stops.
NOTE:
Bolt on LS block will not tighten
against gauge bar; it is used only as a retainer to prevent bar from lifting off block.
Gauge Mounting
