Garwoods HT-3562SG, Руководство по установке и эксплуатации

Страница: 8 / 21

8
4. START USING YOUR COOKER HOOD
There are five touch control buttons, see below:
(Low), (Middle), (High), (Light), (delay).
(1) After power connection, buzzer will make a short sound and the cooker hood
keeps at the stand-by mode.
(2) The fan speed will represent (low)
；
(middle) & (high)
。
Press
the fan speed button, the button will beam and the motor runs as the speed you
selected, press the fan speed button again, the button will be off the motor will
stop.
(3) Press “ ” button, the light will be on, press this button again, the light will be
off.
(4) When the cooker hood is working, if press the “ ” button, the hood will go into
the status of acquiescent working (acquiescent time is 9 mins). When time is
reached, the cooker hood will stop operation.
5.TROUBLESHOOTING
Fault Possible Cause Solution
Light on, but motor
does not work
Fan switch turned off Select a fan switch position.
Fan switch failed Contact your local agent.
Motor failed Contact your local agent.
Light does not work,
motor does not work
House fuses blown Replace fuses.
Power cord loose or disconnected
Refit cord to power outlet.
Switch power outlet on.
Oil leakage
Leakage from the oil cup
Refer to maintenance and cleaning
section to clean the old cup
Leakage from the mesh filter
Refer to maintenance and cleaning
section to clean the mesh filter
Lights not working Broken/Faulty globes Contact your local agent.
Insufficient suction
The distance between the cooker
hood and the gas top is too far Refit the cooker hood to the correct
distance.
The cooker hood
inclines
The fixing screw not tight enough
Tighten the hanging screw and make it
horizontal.
NOTE:
Any electrical repairs to this appliance must conform to your local, state and
federal laws.Please contact the service centre if in any doubt before
undertaking any of the above. Always disconnect the unit from the power source when
opening the unit.