Garrison 046-5681-0, Инструкция по эксплуатации, Страница: 2 / 8

1 2
model no. 46-5681/46-5682
WO
Date
Artist
PROCESS
MAGENTA
PANTONE
287C
PROCESS
BLACK
PANTONE
000
PANTONE
000
PANTONE
000
11/08/13
01a
Brenda
638604 CTC Generic 815446 LITHO FLEXO
mm/dd/yy
02a
xxxxxx
mm/dd/yy
03a
xxxxxx
mm/dd/yy
04a
xxxxxx
mm/dd/yy
05a
xxxxxx
mm/dd/yy
06a
xxxxxx
mm/dd/yy
07a
xxxxxx
46_5681_46_5682
02a
11/26/13
Brenda 02b
11/29/13
Brenda
Installation
HANDLESET WITH ELECTRONIC DEADBOLT
INSTALLATION INSTRUCTIONS
1. Mark The Door With Template
2. Drill Holes
Backset is a distance from door edge to centre of
hole on door face.
Adjustable latch fits both BACKSET of 2-3/8" (60 mm)
and 2 3/4" (70 mm). Please follow the steps shown
below for BACKSET adjustment.
Latch Face Plate
Determine which latch mounting method will
be used and make necessary adjustments.
No adjustment required for square latch face plate.
To change latch face plate
1. Use a flat screwdriver to separate the face plate.
2. Snap selected latch face onto back plate.
Drive-in faceplate installation
Remove the faceplate.
Align the round faceplate with the latch
bolt and push it inside the latch bolt
until you hear the catch click.
Select the height and backset as desired on the door
face; use the TEMPLATE as an indication to mark the
center of the circle on the door face and the center of
the door edge.
Using the marks as a guide to drill a hole
2 1/8" (54 mm) through the door face for the lockset,
then a hole of 1" (25.4 mm) for latch.
3. Install Latch
4. Install Strike
a. Insert the latch and ensure it is parallel to the door
face. Mark the outline of the faceplate, then take
out the latch.
a. To identify the center of strike: close the door, based on the faceplate mark
horizontal center line of strike. Ensure the center of faceplate and the center
of strike are aligned. Use the mark as a guide outlines the strike.
b. Chisel 5/64" (2 mm) deep along the strike outline to allow the strike to be
aligned with the doorframe.
c. Insert the strike and tighten it with screws.
Note: please use “tapping screws” for a metal door.
b. Chisel 5/32" (4 mm) deep along the outline to allow
the faceplate to be aligned with the door edge.
c. Insert the latch and tighten it with screws.
Note: please use tapping screws for a metal door.
d. For drive-in application, drive the latch into the hole
on edge of door and go to step 4.
Installation
a
b
c
d
a
b
c
a
b
c
d
a
b
c
1
2
Drive-In Latch
2 3/4 (70 mm)
a
b
c
d
a
b
c
a
b
c
d
a
b
c
046-5681-0 to 046-5681-8 & 046-7244-0 to 046-7246-6