Garrison 043-5494-2, Инструкция по эксплуатации, Страница: 14 / 26

INSTALLATION INSTRUCTIONS
Exhaust hose installation:
The exhaust hose and adaptor must be installed or removed
in accordance with the usage mode.
The duct can be compressed or extended moderately
according to the installation requirement, but it is
desirable to keep the duct length to a minimum.
pages for window kit installation.
IMPORTANT:
12
(Not applicable to the units without adaptor A, expansion
The exhaust hose can be installed into the wall
Adaptor A
Expansion plug
position
Adaptor
cap
Note:
Cover the hole using the adaptor cap when not in use.
AUTO mode Install
Remove
CAUTION:
Fig.17
Fig.16
min 30CM
max 120CM
Fig. 18
Fig. 19
COOL,HEAT (heat pump type) or
FAN, DRY or HEAT (electrical heat type) mode
1. Install the window exhaust adaptor B onto the exhaust
hose as shown in Fig. 16. Refer to the previous
2. Push the exhaust hose into the air outlet opening along the
plugs and wooden screws of accessories ) .
1. Prepare a hole in the wall. Install the wall exhaust adaptor A
onto the wall (outside) by using 4 expansion plugs and
2. Attach the exhaust hose to wall exhaust adaptor A.
Make sure that there is no obstacle around the air outlet of
exhaust system to work properly.
the exhaust hose (in the range of 500 mm) in order for the
arrow direction (see Fig. 17)
wooden screws, and be sure to fix thoroughly. (See Fig. 18)
DO NOT OVER BEND THE DUCT (See Fig. 19)