Garrick DB20, Инструкция по эксплуатации

Страница: 15 / 24

DRILL PRESS MANUAL
We reserve the right of the amendment addition and deletion of the
specifications, explanatory wording, etc. printed in this manual
15
2. Open the chuck wide enough to accept a new bit.
3. Install the bit so the chuck jaws will grab as much of the bit shank as it can. Do not
allow the chuck to grab the fluted body of the drill bit. Make sure small drill bits do not
get trapped between the edges of two jaws.
4. Tighten the chuck with the chuck key using any of the three key end locations.
5. Remove the chuck key and reconnect power source.
6. Reverse steps to remove drill bit.
6: MAINTENANCE
General
Regular periodic maintenance on your drill press will ensure its optimum performance.
Make a habit of inspecting your machine each time you use it. Check for the following
conditions and repair or replace when necessary:
1.
Loose mounting bolts.
2. Worn switch.
3. Worn or damaged cords and plugs.
4. Damaged V-belt.
5. Any other condition that could hamper the safe operation of this machine.
Tables
The nonpainted surfaces on the drill pressshould be protected against rust and pitting.
Wiping the machine clean after every use ensures that wood dust will not trap moisture
against bare metal surfaces.
Some woodworkers recommend using automotive paste wax on exposed steel and cast
iron surfaces. The wax provides a layer of protection, as well as reducing friction between
lumber and the table, making cuts faster and smoother. Avoid waxes that contain silicone
or other synthetic ingredients. These materials can find their way into lumber that is being
worked, and can make staining and finishing difficult. If you use paste wax, make sure that
it is 100% Carnauba wax.
Lubrication
Inspect regularly for tension and wear. Check pulleys to ensure that they are properly
aligned. See pulley/V-belt sections for proper tension and pulley alignment procedures.
V-Belt