Garrett CSI PRO, Инструкция по эксплуатации

Страница: 51 / 56

50 Garrett Metal Detectors
TROUBLESHOOTING GUIDE
SYMPTOM SOLUTION
No power
1. Ensure batteries are installed in the correct position.
2. Replace all old batteries with all new batteries.
Erratic sounds or
target ID cursor
movement
1. Ensure your searchcoil is securely connected with the
O-ring properly sealed and that the coil cable is snugly
wound around the stem.
2. If using the detector indoors, be aware that excessive
amounts of electrical interference exists, plus excessive
amounts of metal can be found in floors and walls.
3. Determine if you are close to other metal detectors or other
metal structures such as electrical power lines, wire fences,
benches, etc.
4. Adjust frequency.
5. Reduce your sensitivity setting.
Intermittent Signals
Intermittent signals typically mean you’ve found a deeply
buried target or one that is positioned at a difficult angle for
your detector to read. Scan from different directions to help
define the signal. In the case of multiple targets switch to the
ZERO Mode or press the pinpoint button to precisely locate all
targets. (NOTE: Iron targets may cause Intermittent Signals.
You can identify iron targets in ZERO Mode or with the Iron
Audio feature).
I’m not finding
specific targets
Use the ZERO mode, which detects all metal targets to
ensure desired targets are detected. The use of too many
notches of discrimination could prevent some desired objects
from being detected.
Target ID Cursor
bounces
If your Target ID Cursor bounces erratically, chances are
you’ve found an iron target. However, a Target ID Cursor
may bounce if a good target is not parallel to the searchcoil
(e.g. on edge). It may also bounce if there is one or multiple
“junk” targets laying next to the good target. Scan from
different directions until your Target ID Cursor becomes more
stable.
NOTE: Large, flat pieces of iron—depending on their
orientation in the ground—can read as a good target or can
cause erratic Target ID Cursor movement. Use Iron Audio
feature to help identify iron targets.