GARO GNM3T-LP RS485 N, Инструкция по установке и программированию

Страница: 11 / 12

9
!
!
!
Rx
! !
Click left touch area until ”bAud” is visible. Default is 9.6 and this is correct.
If you need to change baud, longpress center touch area and click left or right touch area until 9.6 is visible. Confirm by longpress
center touch area.
!
!
!
Rx
NOTE! Correct Value:Baudrate: 9.6
!
!
!
Rx
! !
Click left touch area until ”PArIty” is visible. Default is ”no” and this is correct.
If you need to change the parity, longpress center touch area and click left or right touch area until ”no” is visible. Confirm by longpress
center touch area. StoP bIt should be ”1”.
Longpress center touch area to confirm.
!
!
!
Rx
Set/verify the Baudrate
10
Set/verify the Parity and stopbit
NOTE! Correct Values:Parity: no Stopbit: 1
11
EN