4
COMMISSIONING
Main unit
The main unit can be powered by the AC adaptor or batteries. Use only the delivered AC adaptor.
Battery installation
1) Remove the battery compartment cover on the rear side of the main unit.
2) Insert 2 pcs AAA batteries (micro)
– observe the correct battery polarity.
3) Close the battery compartment.
Connecting the AC adaptor
1) Connect the AC adaptor plug into the socket on the rear side of the main unit.
2) Connect the other side of the AC adaptor to a mains socket.
After the power supply is connected, the display shows all segments for 3 seconds and a beep sounds.
Then, the wireless sensor signal reception icon
flashes on the display for the outdoor values (OUT)
channel number for 3 minutes.
Wireless sensor GARNI 029
1) Remove the battery compartment cover on the rear side of the wireless sensor.
2) Set the required channel using the switch in the battery compartment.
3) Insert 2 pcs AA (mini) batteries
– observe the correct polarity.
4) Push the TX button. The temperature value measured by the wireless sensor is displayed on the
corresponding channel on the main unit display.
5) Close the battery compartment.
Once the connection of the main unit to the wireless sensor is established, place the main unit
and the wireless sensor in the desired location within the range of the wireless sensor signal.
Using multiple wireless sensors
The main unit allows to connect up to 3 wireless sensors which can be placed at different spots. Each
wireless sensor must be assigned its own channel number (1, 2 and 3).
1) Place the main unit and the wireless sensor next to each other.
2) Remove the battery compartment cover on the side of the wireless sensor.
3) Assign a number to each wireless sensor using the switch so that the numbers are unique.
4) Insert 2 pcs AA (mini) batteries, observe the correct polarity. Then push the TX button. The display
of the main unit will display the temperature value measured by the wireless sensor on the respective
channel
5) To display the readings from a given wireless sensor, select the desired channel on the main unit
using the
+
button.
The reception of the wireless sensor signal can be also started manually by pushing and holding button
+
for 3 seconds.
Placement of the weather station
Main unit
Select the location of the main unit away from direct sunlight. Test the connection to the wireless sensor
before final installation. If there is a problem with the signal reception, select another location. You may also
put the main unit on a flat surface. Placement near TVs, monitors, computers, etc. may negatively affect the
reception of the DCF-77 signal and the wireless sensor signal.
Wireless sensor
Place the wireless sensor away from direct sunlight not to compromise the measurement. Placement
outdoors, at the northern wall is recommended. Obstacles such as walls, concrete, metal structures and
large objects reduce the signal range. Position the wireless sensor vertically for optimum signal
transmission. Maximum open space signal range id 60 meters.
