Garmin Varia HL, Руководство пользователя

Страница: 6 / 12

2
Place a rubber pad around the seat post, if necessary:
• If the seat post diameter is from 27 to 28.6 mm, use the
thicker pad.
• If the seat post diameter is from 30.4 to 31 mm, use the
thinner pad.
• If the seat post diameter is from 31 to 31.8 mm, do not use
a rubber pad.
3
Place the seat-post connector around the rubber pad.
NOTE: You should align the contours on the rubber pad with
the grooves on the inside of the seat-post connector.
4
Replace and tighten the screw.
NOTE: Tighten the seat-post clamp until the mount does not
slide on the seat post, or to a maximum torque specification
of 3 lbf-in. (0.3 N-m). You should check the tightness of the
screw periodically.
5
Align the tabs on the back of the device with the seat-post
mount notches .
6
Press down slightly and turn the device clockwise until it
locks into place.
Installing the Multi-Location Mount
You can use the multi-location mount to install the device on
your seat post, helmet, backpack, or other location. Garmin
recommends that you enable the deceleration indicator only
when mounting the device vertically on your seat post.
1
If necessary, select the correct rubber pad for your seat
post shape.
2
Place the mount on the seat post or other mounting location.
3
Attach the mount securely using one or two bands .
NOTE: You can use the hooks on the center of the mount
when using only one band.
4
Align the tabs on the back of the device with the mount
notches .
5
Press down slightly and turn the device clockwise until it
locks into place.
Varia HL Device Overview
Device key Hold to turn the device on and off.
Select to change operating modes.
Status LED View device status (
Bike Light Status LEDs , page 2 ).
Varia TL Device Overview
Device key
Hold to turn the device on and off.
Select to change operating modes.
Status LED (visible
above the device key)
View device status ( Bike Light Status LEDs ,
page 2 ).
Turning On the Device
1
Hold the device key for 1 second.
The first time you turn on the device, it enters smart mode.
The status LED flashes blue. The device can be controlled by
a paired wireless remote or Edge device.
2
Hold the device key for 2 seconds to turn off the device.
The next time you turn on the device, it enters the last-used
operating mode.
Operating Modes
Varia HL 500 Smart mode (pairing)
Overdrive, high, medium, low, and flash
Varia HL 501 Smart mode (pairing)
High, medium, and low
Varia TL 300 Smart mode (pairing)
High, medium, low, and flash
Varia TL 301 Smart mode (pairing)
High and low
Bike Light Status LEDs
LED Activity Status
Solid red An error occurred while charging.
The device shut down to prevent
overheating.
Alternating blue and
green The device is uploading settings from Garmin
Express
™ .
Alternating blue and red An error occurred while uploading settings
from Garmin Express.
Flashing green The battery is charging.
Solid green Charging is complete.
2 Introduction