Garmin VARIA ERTL616, Руководство пользователя

Страница: 6 / 20

Installing the Device on a Rear Rack
Before you can install the Varia eRTL616, you need 3 mm and 4 mm hex keys and a cable to connect your
device.
1 Complete the required steps based on the configuration of your rear rack:
• If the rear rack can accommodate the friction flange adapter, complete steps 2 through 6.
• If the device can be attached directly to the rear rack, complete steps 7 through 10.
2 Attach the friction flange adapter to your Varia eRTL616 using two M4 screws.
3 Using a 3 mm hex key, tighten the two M4 screws to 1 N-m (9 lbf-in.).
4 Align the hole in the friction flange adapter or extender with the hole in the rear rack of your bike.
5 Using a 4 mm hex key, tighten the M5 screw to 3 N-m (27 lbf-in.).
6 If you are not using a friction flange adapter, align the holes in the rear rack of your bike with the holes on the
back of your Varia eRTL616.
7 Using a 3 mm hex key, tighten the two M4 screws to 1 N-m (9 lbf-in.).
8 Connect the cable to your bike.
Consult the owner's manual for your bike for additional information on connecting devices.
9 Secure the cable so that it does not interfere with any moving parts of the bike.
2 Introduction