background image

Low RPM Limit

: Allows you to adjust the lowest RPM point of 

your boat. If the value does not match the value on the helm 

control or chartplotter, you can adjust the value.

High RPM Limit

: This setting should be 6000 RPM.

Max. Speed

: Allows you to enter the maximum speed of the 

boat when powered by the kicker motor only.

Rudder Gain Settings

NOTE: 

If you set these values too high or too low, the autopilot 

may become overactive, attempting to constantly adjust the 

heading at the slightest deviation. An overactive autopilot can 

cause excess wear on the pump and drain the battery at a 

faster-than-normal rate.
On a helm control, select 

Menu

 > 

Setup

 > 

Dealer Autopilot 

Setup

 > 

Rudder Gains

.

On a chartplotter, select 

Settings

 > 

My Vessel

 > 

Autopilot 

Installation Setup

 > 

Rudder Gains

.

Gain

: Allows you to adjust how tightly the rudder holds a 

heading and makes turns.

Counter Gain

: Allows you to adjust how tightly the rudder 

corrects turn overshoot. If you set this value too low, the 

autopilot can overshoot a turn when attempting to counter the 

original turn.

Steering System Settings

On a helm control, select 

Menu

 > 

Setup

 > 

Dealer Autopilot 

Setup

 > 

Steering System Setup

.

On a chartplotter, select 

Settings

 > 

My Vessel

 > 

Autopilot 

Installation Setup

 > 

Steering System Setup

.

Verify Steering Dir. or Steering Dir.

: Sets the direction the 

rudder must move to turn the vessel to port and to starboard. 

You can test and reverse the steering direction if necessary.

Linkage Compensation or Linkage Comp.

: Tightens or 

loosens the steering. The higher you set the linkage 

compensation value, the more the autopilot will compensate 

for loose steering.

© 2019 Garmin Ltd. or its subsidiaries
Garmin

®

 and the Garmin logo are trademarks of Garmin Ltd. or its subsidiaries, 

registered in the USA and other countries. Reactor

 is a trademark of Garmin Ltd. or its 

subsidiaries. This trademark may not be used without the express permission of Garmin.
Honda

®

 is a registered trademark of Honda Motor Co., Ltd. and its subsidiaries and 

affiliates. Loctite

®

 is a trademark of Henkel Corporation in the U.S. and elsewhere. 

Mercury

®

 is a trademark of Brunswick Corporation. NMEA

®

, NMEA 2000

®

, and the NMEA 

2000 logo are trademarks of the National Marine Electronics Association. Yamaha

®

 is a 

trademark of the Yamaha Motor Corporation. 

5

Содержание Reactor 40 Kicker







Отзывы: