Installing the Handlebar Base
The device includes parts for two handlebar installation
solutions. Custom mounts may require additional hardware.
Installing the U-bolt and Handlebar Base
1
Place the U-bolt around the handlebar , and thread the
ends through the handlebar base .
2
Tighten the nuts to secure the base.
NOTE:
The recommended torque is 50 lbf-in (5.65 N-m). Do
not exceed torque of 80 lbf-in (9.04 N-m).
Installing the Handlebar Base to the Clutch-Clamp or Brake-
Clamp Brackets
1
Remove the two factory bolts on your clutch-clamp or brake-
clamp bracket .
NOTE:
Both 1/4 in. standard and M6 bolts are included.
Match the size of the factory bolts on your clutch-clamp or
brake-clamp bracket.
2
Thread the new bolts through the handlebar base, spacers
, and clutch-clamp or brake-clamp bracket.
3
Tighten the bolts to secure the base.
Attaching the Base Plate to the Motorcycle Mount
NOTICE
Direct, sustained contact with the base plate, or any part of the
motorcycle, may damage the mount over time. To prevent this
kind of damage, you must place the mounting spacers between
the mount and base plate, and make sure that no part of the
device or mount touches the motorcycle.
1
Thread the M4 x 20 mm panhead screws through the
washers , cradle, bushings, spacers , and base plate .
2
Tighten the nuts to secure the base plate.
Attaching the Base Plate to the Handlebar Base
1
Align the ball of the handlebar base and the ball of the
base plate with each end of the double-socket arm .
2
Insert the ball of the handlebar base and the ball of the
base plate into the double-socket arm .
3
Tighten the knob slightly.
4
Adjust for optimal viewing and operation.
5
Tighten the knob to secure the mount.
Specifications
Fuse
3 A
Input voltage
10 to 30 V
Input current
1.5 A Max.
Input current without device
installed
0.5 mA Max.
Operating temperature range
From -20º to 60ºC (from -4º to 140ºF)
Limited Warranty
The Garmin standard limited warranty applies to this accessory.
www.garmin.com/support/warranty
Installation Instructions
3
