Garmin GTX 330, Руководство по установке

Страница: 15 / 48

GTX 330 Installation Manual Page 3-1
190-00207-02 Rev. 1
3. INSTALLATION PROCEDURE
3.1 ANTENNA INSTALLATION
3.1.1 Antenna Installation
Install the antenna according to the antenna manufacturer’s instructions and FAA AC 43.13-2A.
3.1.2 Antenna Cable Connectors
The antenna cable requires a BNC connector at the antenna and a male BNC “Blindmate” connector
(P/N 330-00053-01, supplied with GTX 330 backplate assembly, 011-00582-00/01 at the transponder. Follow BNC
connector manufacturer instructions for assembly of the BNC connector.
3.2 ELECTRICAL CONNECTIONS
All electrical connections, except for the antenna, are made through a single, 62 pin D-subminiature connector.
Figure 2-1 defines the electrical characteristics of all input and output signals and identifies the cable requirements
for each signal. Required connector and associated hardware are supplied in the connector kit (P/N 011-00583-00).
See figures 4-1 and 4-2 for interconnect wiring diagrams.
CAUTION
Check wiring connections for errors before inserting the GTX 330 into the rack.
Incorrect wiring could cause internal component damage.
Pin Contact Part Numbers
62 pin connector (P3301)
Wire Gauge 22-28 AWG
GARMIN P/N 336-00021-00
Military P/N M39029/58-360
Recommended Crimp Tools
Wire Gauge 20-24 AWG
Hand Crimping
Tool
Positioner Insertion/
Extraction Tool
Military P/N M22520/2-01 M22520/2-08 M81969/1-02
Positronic 9507 9502-5 M81969/1-02
ITT Cannon 995-0001-584 995-0001-604 980-2000-426
AMP 601966-1 601966-5 91067-2
Daniels AFM8 K13-1 M24308/1-02
Astro 615717 615724 M81969/1-02
NOTES
1. Insertion/extraction tools from ITT Cannon are all plastic; others are plastic with metal tip.
2.
Non-GARMIN part numbers shown are not maintained by GARMIN and consequently are subject to
change without notice.
3. All wires must be passed through the backshell before being assembled to connector.