15 Starting in one corner of the mounting location, place a nut plate on the back of the mounting surface,
lining up the large and small holes.
The raised portion of the nut plate should fit into the larger hole.
16 Secure the nut plate to the mounting surface by fastening an included M3 screw through the smaller
3.6 mm (
9
/
64
in.) hole.
17 Repeat steps 15 and 16 for each of the nut plates along the top and bottom of the device.
18 If necessary, install the gaskets and hard stops on the device (
Installing the Gasket and Hard Stops,
).
19 If you will not have access to the back of the device after you mount it, connect all necessary cables to the
device and insert a microSD card before placing it into the cutout.
NOTE: To prevent corrosion of the metal contacts, cover unused connectors with the attached weather caps.
20 Apply marine sealant along the edges of the device where it contacts the mounting surface.
21 Place the device into the cutout.
22 Secure the device to the mounting surface using the included M4 screws or wood screws, depending on
the mounting method.
23 Carefully remove and discard the rubber protective bumper.
24 Install the decorative trim caps (
Installing and Removing the Decorative Trim Caps, page 7
).
5
