Mounting the GPSMAP 185 Sounder Unit
The GPSMAP 185 Sounders compact, waterproof case is suitable for mounting
in exposed locations or at the nav station. The unit comes with a gimbal bracket
that can be used for surface or overhead mounting. When choosing a location for
the display unit, make sure you consider the following conditions:
There should be at least a 3 (5 cm) clearance behind the case to allow connection of the
antenna, power/data cables.
You should provide adequate clearance for the Micro G-chart cartridge cover to swing
open freely. You may have to swivel the unit to get a firm grip on the cartridge.
The mounting surface should be heavy enough to support the unit and protect it from
excessive vibration and shock.
To install the GPSMAP 185 Sounder unit:
1. Place the mounting bracket in the desired location.
2. Mark and drill the four mounting holes for the fastener you are using.
3. Fasten the bracket to the surface using the appropriate fastener.
4. Insert the GPSMAP 185 Sounder into the mounting bracket. The bracket is designed for a
tight fit to provide additional support when swiveling the unit.
5. Screw the two mounting knobs through the bracket and into the display case.
6. Connect the power/data/transducer and antenna cables to the back of the unit, making
sure the locking rings are fully tightened on both connectors.
83
SECTION
A
APPENDIX
Installation
The mounting bracket can be rotated, allowing
the unit to be mounted overhead or on a verti-
cal surface.